DecExpert IF-1330 Manuel de démarrage rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} DecExpert IF-1330. DecExpert IF-1330 17 pages.

 NEVER use a wall mount bracket from another manufacturer.

 This product is not intended to be a primary heat source. It is for supplemental heat only.

 INDOOR use only! NEVER use this heater outdoors! Doing so may result in electric shock!

 Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside!

 ALWAYS turn this heater off before unplugging it from the outlet.

 ALWAYS disconnect this unit from the power supply before performing any assembly or

cleaning, or before relocating the electric fireplace.

 NEVER leave this heater unattended. ALWAYS unplug this heater when not in use.

 ALWAYS store this heater in a dry location.NEVER use the fireplace if it has become wet.

 NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or

connections. Plugging this heater into a faulty outlet could result in electric arcing within

the outlet that could cause the outlet to overheat or catch fire.

 ALWAYS check your heater cord and plug connections with each use!

i) MAKE SURE the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs

can cause the outlet to overheat.

ii) Heaters draw more current than small appliances. Overheating may occur even if it

has not occurred with the use of other appliances.

iii) During use check frequently to see if the plug outlet or face plate is HOT!

iv) If the outlet or face plate is HOT, discontinue use immediately and have a qualified

electrician inspect and/or replace the faulty outlets.

 The power cord supplied with the heater

has a plug with two flat blades (live and

neutral) and one round pin (ground). If a 3-

slot receptacle is not available, an adapter

MUST be used. The adapter MUST be

properly grounded to the outlet box (see

figure

INCLUDED.)

 SAVE THESE INSTRUCTIONS!

PREPARATION

This product includes a GLASS panel! Always use extreme caution when handing

glass. Failure to do so could result in personal injury or property damage.

Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts

and assembly steps are grounded for wall-hanging or recessing use. Check the parts list to make

sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever

possible.

You will need the following tools (not included): Phillips screwdriver; stud finder; level;

tape measure; electric drill; 1/4" wood drill bit, hammer.

right).(Note:Adapter

NOT