Gamma 6002 Manuel du propriétaire - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gamma 6002. Gamma 6002 20 pages.

ASSEMBLY INSTRUCTIONS

Support Post Installation

The support post assemblies are precision

aligned at the factory and are marked for

proper installation on the turntable.

Install the marked support post on the marked

side of the turntable. Align the threaded hole

in the bottom of the support post with the slot

in the turntable. Screw the lever lock bolt with

washer into the bottom of the support post

and tighten gently.Position the washer with

the rounded edge toward the turntable.

Repeat procedure on the opposite side.

Installing the Fixed Clamps

To install the clamps, remove the winged lock

knob to separate the knob from the lower

guide bushing. Be careful not to lose the

thrust bearing components located in the

center recess of the knob.

Align the clamp base with the clamp slot of

the turntable base. Insert the clamp guide

bushing into the clamp from the bottom of the

turntable making sure to engage the guide

with the clamp slot.

Place the load bushing into the top of the

clamp base mating it to the lower guide

bushing.

After checking that the thrust bearing is posi-

tioned correctly in the base of the winged lock

knob, screw the knob into the base bushing

until fully seated.