Gamma Progression 602 FC Manuel du propriétaire - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gamma Progression 602 FC. Gamma Progression 602 FC 16 pages.
Également pour Gamma Progression 602 FC : Manuel du propriétaire (16 pages)
Imprimer la page
while tensioning, adjust the gap between the clamp jaws as per the instructions on page 12.
STRINGING THE FRAME
Setting Tension
To set the stringing tension, loosen the
locking knob on the side of the drop weight.
Slide the weight in the appropriate direction
until the face closest to the string gripper is
indexed with the desired tension mark on
the tension bar.
The drop weight is of a two piece design.
When assembled, it will accommodate ten-
sions from 20 to 90 lbs. For tensions from 8
to 20 lbs., remove the 5mm bolt on the face of
the drop weight, and use the smaller portion
of the weight as described above.
Note: Tensions above 77lbs. require removal
of the drop weight bar end cap.
Fixed Clamp Operation
The fixed clamps are of a dual action design.
The string clamp and the clamp base operate
independently of one another.
To clamp a string, lift the clamp head and
place the string between the jaws. Depress
the clamp head lever to secure the string.
The clamping pressure applied to the string
should be adjusted to provide sufficient pres-
sure to secure the string when subjected to
the desired pulling tension.
The diamond coated gripper plates provide
for increased friction between the clamps
and the string to allow for reduced clamping
pressure while securing and holding the string
under tension.
Note: If the string slips in the string clamp
7