Gamma Progression 602 FC Manuel du propriétaire - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gamma Progression 602 FC. Gamma Progression 602 FC 16 pages.
Également pour Gamma Progression 602 FC : Manuel du propriétaire (16 pages)
Imprimer la page
ASSEMBLY INSTRUCTIONS
Engaging the Drop Weight Bar Stop
The stringing machine is shipped with the drop weight
bar in the horizontal position. To prevent racquet
damage during stringing, the bar stop must be engaged.
Remove the machine base from the shipping carton
being careful to avoid lifting by the plastic cover.
Hold the drop weight bar in the vertical position as shown
while turning the stop screw clockwise with the supplied
5mm hex wrench.
Installing the Turntable
The turntable is located under the foam packing in the
bottom of the shipping carton.
Insert the center post of the turntable into the bushing
of the stringing machine base.
Installing the Frame Support Posts
The GAMMA 600FC support post assemblies are pre-
cision aligned at the factory and are marked for proper
installation on the turntable.
Install the support post with the dot on its base to an
identical dot on the turntable. Align the threaded hole in
the bottom of the frame support post with the slot in the
turntable. Screw the lever lock bolt with washer into the
bottom of the support post and tighten gently.Position
the washer the rounded side toward the turntable.
Repeat procedure on the opposite side of the turntable
3