Gamma X-6 Manuel du propriétaire - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gamma X-6. Gamma X-6 15 pages.
Également pour Gamma X-6 : Manuel du propriétaire (16 pages)

Imprimer la page

MAINTENANCE and ADJUSTMENTS

Your GAMMA stringing machine is adjusted for optimum performance at the factory and needs

no further adjustments before use. After extensive use however, the machine may need minor

adjusments as follows :

be adjusted by turning the adjustment knob counterclockwise.

The clamp jaws must be clean and free from dirt, oil, and any string coating for them to grip

properly. Clean the clamp jaws with alcohol.

Note: The string clamps supplied with your stringing machine can accomodate tight string

patterns such as badminton. Depending on the string pattern, the clamp will spread the strings

slightly which will not compromise the quality of the string job.

Turntable Bushing Adjustment

The turntable bushing is adjusted at the

factory for optimum performance. After time

and use, the turntable bushings may need

minor adjustment. An adjustment is indi-

cated when noticeable turntable looseness

or wobble occurs while stringing.

To adjust the fit between the turntable pin

and the bushings, tighten the set screw at

the top of the bushing using a 3mm hex

wrench. Tighten until the turntable rotates

smoothly without excessive free play.

Adjusting the Clamps

The clamps provided with your stringing

machine will need minor adjustments ac-

cording to string type, construction, and

gauge.

To adjust, route the string through the racquet

Adjustment

as if you were beginning the main strings.

Knob

Clamp the strings and pull tension. If the

string slips through the jaws of the clamp,

tighten the clamp by turning the adjustment

knob opposite of the handle, in the clockwise

direction. If the clamp leaves impressions or

damages the string, it is too tight and must