Gamma X-Els Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gamma X-Els. Gamma X-Els 20 pages.
Également pour Gamma X-Els : Manuel du propriétaire (20 pages)
- 1. Table of Contents
- 2. Warranty
- 3. Features
- 4. Assembly Instructions
- 5. Power Connection & Controls
- 6. Mounting the Frame
- 7. Stringing the Frame
- 8. Additional Features
- 9. Pathfinder Awl
- 10. Calibration
- 11. Maintenance & Adjustments
- 12. Troubleshooting Tips
- 13. Notes
- 14. Parts List
- 15. Parts Drawing
STRINGING THE FRAME
to allow for reduced clamping pressure while securing and holding the string under tension.
Note that excessive pressure can damage both the strings and String Clamp.
Clamp Base Operation
To lock the string clamp base to the turntable,
rotate the clamp base locking lever clockwise.
To release the string clamp base from the
turntable, rotate the clamp base locking lever
counter-clockwise.
The Locking Lever should be tightened
enough to prevent clamp base slippage on
the turntable, when the desired tension is
placed on the string. To go from the loose
position to the clamped position and back,
generally requires the rotation permitted by
the slot in the clamp base.
String Clamp Operation
The string c
lamps are a dual action design
where the string clamp and clamp base oper-
ate independently of one another.
To clamp a string, lift the clamp head and
place the string between the jaws and de-
press the string clamp lever to secure the
string. The clamping pressure applied to the
string should be adjusted to provide sufficient
pressure to secure the string when subjected
to the desired pulling tension. The diamond
coated gripper plates provide for increased
friction between the clamps and the string
Getting Started
To begin stringing the main strings, thread
the two ends of the string through the two
center holes at the appropriate end of the
frame and continue through the opposite
center holes. Thread one end of the string
through the adjacent grommet hole and pull
excess by hand.
Secure one of the strings using a string clamp.
9