Major Manufacturing HIT-40AR3 Manuel d'instructions - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Major Manufacturing HIT-40AR3. Major Manufacturing HIT-40AR3 9 pages. Lip strike template
Place the router bit in the starting hole and with firm
control of the router follow the HIT-40 template and feed
the router slowly in a CLOCKWISE DIRECTION.
Route in a line up the front portion of the jamb staying just
inside the frame to complete the opening. ( If you route
out the front of the frame at this point, there will be a large
gap in front of the strike that will be visible. ) This area
will be routed out after the bit has been adjusted to a new
cutting depth.
IMPORTANT!! DO NOT ROUTE THROUGH THE
FRONT EDGE OF THE JAMB. MAKE THE VERTICLE
CUT ABOUT 3/8" INSIDE THE FRONT EDGE.
Copyright 2007—Major Manu-
facturing
cut through in the step above. Adjust the depth of the
router to cut the
thickness of the jamb material only, this should be a
cut depth of only about 1/8 inch. Use the router to
nibble away this area.
Copyright 2007—Major Manufacturing
Page 7
Make sure the base of the
router is held flat on the
routing template. When com-
pleted with the cut, turn the
router off and wait for the bit to
come to a complete stop be-
fore removing it from the tem-
plate. Failure to do so may
This is the area you did not