Gamma Sports STII Manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Gamma Sports STII. Gamma Sports STII 10 pages.

Imprimer la page

ASSEMBLY INSTRUCTIONS

Support Post Installation (cont'd)

Place the support post onto the central slot

of the turntable. With your ﬁ ngers placed

through the large hole in the underside of the

turntable, press the mounting plate against

the inside top surface of the turntable while

aligning the hole in the support post with the

hole in the mounting plate and ﬁ x them with

the mounting bolt. Repeat procedure on to

attach the support post on the opposite side

of the turntable.

Clamp Head Installation

The post of the string clamp head and tube of

the string clamp base are treated with grease

to provide protection against corrosion during

shipping. Remove any excessive grease with

a clean cloth prior to use. The post and tube

may also be cleaned with isopropyl alcohol.

After this type of thorough cleaning, the post

and tube should be treated with a light coating

of machine oil to protect the surfaces against

corrosion and to ensure smooth operation.

Installing the Tensioner

Remove the button head screw and washer

located at the end of the tensioner bar with

the 3 mm hex wrench provided. Slide the

tensioner onto the bar, being careful to align

the bar with all of the bearings and the drive

gear with the gear track. Replace the screw

and washer into the end of the tensioner bar.

Note: The tensioner bar is equipped with

a tensioner travel stop to limit travel of the

tensioner along the bar. See page 10 for

more details about this feature.

MAINTENANCE & ADJUSTMENTS

Adjusting the Tensioner Brake

After stringing many racquets, the brake

of the tensioner may need to be adjusted.

With the brake lever engaged in the latch,

insert the 6mm allen wrench into the bolt (A)

located at the base of the brake lever. It can be

accessed through the hole on the face of the

tensioner cover (above the 'GAMMA' logo).

Note: The tensioner cover does not need to

be removed for the adjustment. The cover

has been removed in the pictures for illustra-

tion purposes.

While holding the 6mm brake lever adjust-

ment bolt (A), loosen the hex bolt (B) located

on the back side of the tensioner frame with

the 4 mm allen wrench.

Note: The hex bolt should only be loosened

and must not be completely removed.

To tighten the braking mechanism, turn the

set screw (A) counter clockwise by about 1/8

turn. Re-tighten the allen screw (B) on the

back side of the tensioner frame and check

for brake tightness. The tensioner should

move freely along the track with the brake

lever engaged and should hold tension with

the brake lever released. If more adjustment

is needed, repeat steps above until properly

adjusted.