Green Brook Orion Range Manuel de démarrage rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Green Brook Orion Range. Green Brook Orion Range 2 pages. Infra-red microwave presence detector- adjustable
Également pour Green Brook Orion Range : Manuel (2 pages)

Imprimer la page

Switch the mains supply OFF first to prevent electric shock.

Decide on mounting position of sensor in and

screw into position using the two mounting lugs

at either end. (ensure there is no

wiring/gas/water

services directly behind the

screws) refer to Dia:1.

Connect the mains in and load out wires according to Dia:1 and Dia:2.

1. First connection-wire diagram (without push switch override)

2. Second connection-wire diagram (with push switch override)

Dia:2

Note: Full dim functions only available when sensor used with a compatible 1 - 10V driver.

Dia:1

or Lamp

1. Slide all 9 slide switches to the 'Up'

position .

2. Re-connect mains supply, allow 30 seconds for the sensor to warm-up, and then perform a walk-by in front of the

sensor; lamp should turn on and stay on for approximately 5 seconds, and will go off if no further

movement is detected.

ADJUSTING THE DAYLIGHT SENSOR (LUX) CONTROL

1. Lux levels can be set between 2000 Lux (daylight) and 2 Lux

(night), using a combination of slide switches, see Table 1.

2. Set control to operate at your required daylight level.

ADJUSTING THE 'TIME HOLD-ON' CONTROL

Time control for lamp full brightness 'ON'can be adjusted

between 5 seconds and 30 minutes, using a combination of

slide switches, see Table 2.

Set control to operate at your required time period.

ADJUSTING THE DETECTION RANGE (SENSITIVITY) CONTROL

Sensitivity can be adjusted between a detection cone of 1

meter (10%) and a detection cone of 8 meters (100%)

using a combination of slide switches, see Table 3.

Set control to operate at your required time period.

ADJUSTING THE STAND-BY DIMMING LEVEL CONTROL

5 %

1 %

Adjusts the brightness of the lamp in dimmed standby mode

after 100% light level has timed out.

Dimming light level can be set to between 10% and 50%,

using a combination of slide switches, see Table 4.

ADJUSTING THE 'DIMMED STAND BY PERIOD'

Adjusts the length of time the lamp stays in dimmed mode.

Standby dim period can be set between 10 seconds and

1 hour, using a combination of slide switches, see Table 5.

'means lamp stays on standby dimming level and

never turns off.

Os means no dimming function.

TESTING

Table:1

Table:2

Table:3

Table:4

Table:5