Major Manufacturing DRILL MASTER HIT-44 Manuel du propriétaire - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Major Manufacturing DRILL MASTER HIT-44. Major Manufacturing DRILL MASTER HIT-44 12 pages. Drill master

Imprimer la page

TO ADJUST CENTERING

BRASS

KNURLED

KNOB

ALLEN

SCREW

ON YOKE

BRASS

KNOB

The HIT-44 has a unique feature in the fact the centering can be adjusted.

This will allow you to drill a centered latch hole in the edge of the door or

one that is off centered. This is handy in case a door has an additional

skin or plywood added on for re-enforcement. By loosening the allen

screw holding the brass KNURLED knob and you can move one jaw

independent from the other. This will move the centering of the latch hole

by the amount you moved the jaw. Adjust the knob until you have the hole

where you want it. Tighten the allen screw and drill the latch hole. It is a

good idea to re-center your drill guide after use so a door won't be

mis-drilled next time. To re-center, turn the large main clamp knob until the

clamp jaw on that side is flush with the core cut out . Loosen the brass

KNURLED knob on the opposite side and adjust that jaw until it is also

flush with the core cut out. Tighten the allen screw and the unit is now

centered.

HIT-44 IS CENTERED WHEN

RIGHT AND LEFT HAND JAW

IS FLUSH WITH CORE CUT

OUT

MAIN CLAMP

KNOB