IKEA Anratta Manuel de démarrage rapide - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} IKEA Anratta. IKEA Anratta 16 pages. 1000w
Également pour IKEA Anratta : Manuel (24 pages), Manuel d'installation (26 pages), Manuel (8 pages), Manuel (36 pages), Manuel (36 pages), Manuel (36 pages), Manuel (40 pages), Manuel (20 pages)

IKEA Anratta Manuel de démarrage rapide
ENGLISH
3. Close the door as far as it will go (A), lift it up (B) and turn it
(C) until it is released (D) (Fig. 2, 3, 4).
To refit the door
1.
Insert the hinges in their seats.
2. Open the door fully.
3. Lower the two catches.
4. Close the door

What to do if ...

Problem
The oven does not work.
The display shows the letter
"F" followed by a number
Before calling the Authorized Service Centre:
1.
See if you can solve the problem yourself with the help of the
suggestions given in the "What to do if ..." table.
2. Switch the appliance off and back on again it to see if the
fault persists.
If after the above checks the fault still occurs, contact IKEA
Authorized Service Centre.
Always specify:
a brief description of the fault;
the type and exact model of the oven;
If any repairs are required, please contact IKEA Authorized Service Centre (to guarantee that original spare parts will be used and
repairs carried out correctly).
Fig. 2
Fig. 3
Fig. 4
Possible cause
No presence of mains electrical power.
The oven is not connected to the electrical
supply.
Software problem
5. Cleaning the glass
1.
After removing the door and resting it on a soft surface
with the handle downwards, simultaneously press the two
retaining clips and remove the upper edge of the door by
pulling it towards you.
2. Lift and firmly hold the inner glass with both hands, remove
it and place it on a soft surface before cleaning it. Do the
same operation for the intermediate glass.
3. To reposition both the intermediate and the internal glass
properly, be sure that the "R" can be seen in the left corner.
First insert the long side of the glass indicated by "R" into the
support seats, then lower it into position.
4. Refit the upper edge: A click will indicate correct positioning.
Make sure the seal is secure before refitting the door.
To replace the lamp
1.
Disconnect the oven from the power supply.
2. Unscrew the lamp cover (Fig. 5), replace the lamp (see note
for lamp type) and screw the lamp cover back on.
3. Reconnect the oven to the power supply.
NOTE:
-
Only use 25W/230 V type G9, T300°C halogen lamps.
-
The lamp used in the appliance is specifically designed for
electrical appliances and it is not suitable for household
room illumination (Commission Regulation (EC) No
244/2009).
-
Lamps are available from IKEA Authorized Service Centre.
Solution
Verify the presence of mains electrical power.
Connect the oven to the power supply.
Contact you nearest After-sales Service Centre and
state the letter or number that follows the letter "F"
the service number (number after the word Service on the
rating plate), located on the right hand edge of the oven
cavity (visible when the oven door is open);
your full address;
your telephone number.
Fig. 5
12