Major tech MT723 Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Major tech MT723. Major tech MT723 16 pages. Ac/dc trms clamp meter

Imprimer la page

1. Safety

1.1. lnternational Safety Symbols

This symbol, adjacent to another symbol or terminal, indicates

the user must refer to the manual for further information.

This symbol, adjacent to a terminal, indicates that, under

normal use,hazardous voltages may be present.

Double insulation.

Application around and removal from uninsulated hazardous

live conductors is permitted.

1.2. SAFETY NOTES

• Do not exceed the maximum allowable input range of any function.

• Do not apply voltage to meter when resistance function is selected.

• Set the function switch OFF when the meter is not in use.

• Remove the battery if meter is to be stored for longer than 60 days.

1.3. WARNINGS

• Set function switch to the appropriate position before measuring.

• When measuring volts do not switch to current resistance modes.

• Do not measure current on a circuit whose voltage exceeds 600V.

• When changing ranges always disconnect the test leads from the circuit

under test.

1.4. CAUTIONS

! Improper use of this meter can cause damage, shock, injury or death.

Read and understand this user manual before operating the meter.

! Always remove the test leads before replacing the battery or fuses.

! Inspect the condition of the test leads and the meter itself for any

damage before operating the meter. Repair or replace if damaged before

use.

! Use great care when making measurements if the voltages are greater

than 25VAC RMS or 35VDC. These voltages are considered a shock

hazard.

! Always discharge capacitors and remove power from the device under

test before performing Diode, Resistance or Continuity tests.

! Voltage checks on electrical outlets can be difficult and misleading

because of the uncertainty of connection to the recessed electrical

contacts. Other means should be used to ensure that the terminals are

not "live".

! If the equipment is used in a manner not specified by the manufacturer,

the protection provided by the equipment may be impaired.