Major tech MT1881 IV Manuel d'instruction - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Major tech MT1881 IV. Major tech MT1881 IV 20 pages. Professional digital multimeter
Imprimer la page
6.3. DC CURRENT MEASUREMENT
CAUTION: Do not make 10A current measurements for longer than 30
seconds. Exceeding 30 seconds may cause damage to the
meter and/or the test leads.
1. Insert the black test lead banana plug into the
2. For current measurements up to
switch to the µA AC/DC Position and insert the red test lead banana
plug into the µA/mA input jack.
3. For current measurements up to
to the
mA AC/DC
into the µA/mA input jack.
4.
For current measurements up to
the
10A AC/DC
into the 10A input jack.
5. Press the
MODE
6. Remove power from the circuit under test, then open up the circuit at
the point where you wish to measure current.
7.
Connect the black test probe tip and the red test probe tip in series to
the circuits current you want to measure
8. Apply power to the circuit.
9. Read the current on the display.
6.4. AC CURRENT (FREQUENCY, DUTY CYCLE) MEASUREMENT
CAUTION: Do not make 10A current measurements for longer than 30
seconds. Exceeding 30 seconds may cause damage to the
meter and/or the test leads.
1. Insert the black test lead banana plug into the negative COM input
jack.
2. For current measurements up to 6000 µA AC, set the function
switch to the µA AC/DC position and insert the red test lead banana
plug into the µA/mA input jack.
3. For current measurements up to 600mA AC, set the function switch
to the mA AC/DC position and insert the red test lead banana plug
into the µA/mA input jack.
4.
For current measurements up to 10A AC, set the function switch to
the 10A AC/DC position and insert the red test lead banana plug
into the 10A input jack.
5. Press the MODE Button to indicate "AC" on the display.
6. Remove power from the circuit under test, then open up the circuit at
the point where you wish to measure current.
6000 µA DC
600mA DC
position
and insert the red test lead banana plug
10A DC
position and
insert the red test lead banana plug
Button to indicate "
COM
, set the function
, set the function switch
, set the function switch to
DC
" on the display.
input jack.
9