Major tech MT25 Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Major tech MT25. Major tech MT25 16 pages. 600v ac/dc multimeter

Imprimer la page
Major tech MT25 Manuel d'instruction

5.15. Battery Replacement

! WARNING:
To avoid electric shock, remove the test leads from the meter
before removing the battery/fuse cover.
1.
Lift up the tilt stand.
2.
Loosen the two Phillips screws on the battery/fuse cover.
3.
Remove the battery/fuse cover.
4.
Replace the batteries with 3 x AAA 1.5V batteries.
5.
Observe proper polarity as shown inside battery compartment.
6.
Install the battery cover and tighten the screws

5.16. Fuse Replacement

! WARNING:
To avoid electric shock, remove the test leads from the meter
before removing the battery/fuse cover.
1.
Lift up the tilt stand.
2.
Loosen the two Phillips screws on the battery/fuse cover.
3.
Remove the battery/fuse cover.
4.
Gently remove fuse and install new fuse into the holder.
5.
Always use a UL recognized fuse of the proper size and value: 10A/600V
(5 x 20mm) fast blow.
6.
Install the battery cover and tighten the screws.
! WARNING:
To avoid electric shock, do not operate meter until the battery/
fuse cover is securely fastened to the meter.

6. Maintenance

This Multimeter is designed to provide years of dependable service, if the
following care instructions are performed:
1.
KEEP THE METER DRY. If it gets wet, wipe it off.
2.
USE AND STORE THE METER IN NORMAL TEMPERATURES. Temperature
extremes can shorten the life of the electronic parts and distort or melt
plastic parts.
3.
HANDLE THE METER GENTLY AND CAREFULLY. Dropping it can damage
the electronic parts or the case.
4.
KEEP THE METER CLEAN. Wipe the case occasional ly with a damp cloth.
DO NOT use chemicals, cleaning solvents, or detergents.
5.
USE ONLY FRESH BATTERIES OF THE RECOMMENDED SIZE AND TYPE.
Remove old or weak batteries so they do not leak and damage the unit.
6.
IF THE METER IS TO BE STORED FOR A LONG PERIOD OF TIME, the
batteries should be removed to prevent damage to the unit.
11