Major tech MT915 Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Major tech MT915. Major tech MT915 8 pages. 2-in-1 cable identifier & digital multimeter
Également pour Major tech MT915 : Manuel d'instruction (12 pages)

Imprimer la page

2. Press the "DATA HOLD" button to return to normal

operation.

Auto Power Off

The auto off feature will turn the meter off after 15

minutes.

Replacing The Fuses

1. Disconnect the test leads from the meter.

2. Remove the protective rubber holster.

3. Remove the battery cover (two "B" screws) and the

battery.

4. Remove the four "A" screws securing the rear cover.

5. Lift the center circuit board straight up from the

connectors to gain access to the fuse holders.

6. Gently remove the old fuse and install the new fuse

into the holder.

Always use a fuse of the proper size and value

(0.2A/250V fast blow for the 200mA range).

8. Align the center board with the connectors and gently

press into place.

9. Replace and secure the rear cover, battery and battery

cover.

WARNING: To avoid electric shock, disconnect the test

leads from any source of voltage before removing the fuse

cover.

Battery Replacement

1. Both for the transmitter or receiver, when the "Low

battery indicator" is lit, it is necessary to replace the

battery. Measurements may still be made several hours

after the low battery indicator.

2. Remove the bottom cover and secure the screw.

3. Replace old battery with fresh two 1.5V AAA or 9V type

battery.

4. Replace the bottom cover and secure the screw.