Frigidaire CHEST FREEZER Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Frigidaire CHEST FREEZER. Frigidaire CHEST FREEZER 12 pages.

First Steps

The following tools are required to assemble and install the casters to the unit:

Caster Set-up

1. With an assistant, tilt the unit until it is resting on its back. Take care to protect the back

from being scratched during this process.

2. Using the wrench provided and the sixteen (16) screws, install all four (4) casters in the

tapped holes in the bottom of the unit. Tighten the screws securely.

3. With an assistant, tilt the unit back up onto its casters.

4. To prevent unintended movement, block casters once the unit is in place.

Appliance Placement

Leave a three (3) inch space on all sides and the back of the cabinet for ease of installation,

proper air circulation and electrical connections. Choose a place that is near a grounded electrical

outlet. For the most efficient operation, the appliance should be located where surrounding

temperatures will not drop below 40ºF (5ºC) or exceed 110ºF (43ºC). Additional compressor

heaters are not recommended.

Insulation

The insulated space of this cabinet is sealed to maintain peak efficiency. DO NOT drill holes in the

cabinet. Holes drilled in the cabinet may destroy that seal and damage electrical wiring located

in the insulated space. It may also pierce and damage the sealed refrigeration system in the

insulated space.

DAMAGED ELECTRICAL WIRING OR WET INSULATION CAUSED BY DRILLING WILL

VOID THE WARRANTY.

Glass Lid Models

• There are two (2) glass lids, a smaller one that fits in the lower track of the freezer and a

larger one that fits in the upper track. The lower track has two (2) round retaining studs

and the upper has four (4) round retaining studs.

• Install the lower glass first. Again, the lower glass is the smaller of the two. It has a flexible

vinyl seal and a lock plate. The flexible seal should be facing up and positioned on the end

away from the two round retaining studs. Place the panel in the center and slide along the

lower track until it is secure under the two retaining studs.

• Place the upper glass panel over the lower glass panel already in place. Slide it over the

lower lid past the flexible seal. You will notice a slight resistance with the lower lid gasket.

Slide the upper panel under the four studs on the upper track of the frame.

• When properly installed, there is a seal formed by the flexible vinyl seal between the two

glass lids.

A Wrench (1)

B Screws (16)

C Casters (4)