Jalousie-Welt Pergola PRO Fonctionnement et entretien, instructions d'expédition, de déballage et d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Fonctionnement et entretien, instructions d'expédition, de déballage et d'installation pour {nom_de_la_catégorie} Jalousie-Welt Pergola PRO. Jalousie-Welt Pergola PRO 20 pages.

Imprimer la page

3.8.3. Laying electric cables (if motor drive was ordered)

Drill out grommet for electrical conduit. Power to the motor drive should be prepared in accordance

with the relevant provisions.

3.8.4. Fix the pergola awning frame

Attach the right pilar to the prepared substrate.

Place the right guide (1) from the wall in the mounting bracket and lock screw (2)

Embed guide holder (3) on the head of the column (4) and secure with screws (5).

Possible slight readjustment of the guide bracket (3) can be made loosening slightly screw (6) and

after adjustment tighten again.

The same way like for right guide install next (left) guide (7). This operation is performed together

with the rear face of the beam (8) in

the sockets of the head (4).

This action consists in inserting and studs mounted on the front ends of the beam (8)

socket head (4) and secure the Allen screws (9) located in the head (4).

Note

When selecting the mounting means that the maximum load on the awning is

132 N/m². In addition, you will be taken into account the weight of the awning,

which is ca. 7 kg/m².

Note

The main task of the pergola awning PRO is the protection from sunlight. There is also

the possibility of extra protection from the rain. The effectiveness of the removal of

water depends on the awning fabric, inclination angle of the pergola and used

accessories like gutter system and water blockade on sides.

Right side of the awning

page: 11 / 20