KitchenAid KECC506RBL02 Manuel d'instructions d'installation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid KECC506RBL02. KitchenAid KECC506RBL02 16 pages. Electric cooktop
Également pour KitchenAid KECC506RBL02 : Liste des pièces (3 pages)
Imprimer la page
3-Wire Cable from Power Supply to 3-Wire
Cable from
Cooktop
IMPORTANT: Use the 3-wire cable from power supply where local
codes permit connecting the frame-ground
conductor to the
neutral (white) junction box wire:
G
H
A. Red wires
B. Bare or green wire from
cooktop
C. 3-wire cable (from cooktop)
D. Junction
box
E. White wire (from power supply)
F. UL listed wire nut
G. Black wire
H. UL listed or CSA approved
conduit connector
1. Disconnect power
2. Remove junction box cover, if present.
3. Connect the flexible cable conduit from the cooktop to the
junction box using a UL listed or CSA approved conduit
connector.
4. Tighten screws on conduit connector if present.
5. Connect the two black wires together using the UL listed wire
nuts.
6. Connect the two red wires together using the UL listed wire
nuts.
7. Connect the green or bare cooktop cable wires to the white
(neutral) wire in the junction box using the UL listed wire nuts.
8. Install junction box cover.
9. Reconnect power.
NOTE: This section applies only if you are using clamp brackets.
A
........................................................
B
..................................
i
i/i_
iii
i
i
...............................
O
.................................
E
A. Glass cooktop
D. Countertop
B. Burner box
E. 2Y," (6.4 cm) clamping screw
C. Clamp bracket
E Attachment
screw
1. Place the 21/2 '' (6.4 cm) clamping screws into the brackets.
2. Check to be sure the cooktop is still level.
3. Use a flat-blade screwdriver to tighten the screws against the
countertop. Do not overtighten.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Dispose of/recycle all packaging materials.
3. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by protective shipping
material. Dry thoroughly with a soft cloth. For more
information, see the "Cooktop Care" section of the
Use and Care Guide.
4. Read "Cooktop Use" in the cooktop Use and Care Guide.
NOTE: If the cooktop does not work after turning on the power,
check that a circuit breaker has not tripped or a house fuse has
not blown. See "Troubleshooting"
section in the Use and Care
Guide for further information.
If you need Assistance
or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your cooktop.