Majorcom: MX-30 Manuel d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Majorcom: MX-30. Majorcom: MX-30 11 pages.

speakers to be placed on your distribution line is in relation to the power allocated to each speaker. The total

wattage set on the secondary side of the transformers on your speaker line must not exceed the maximum RMS

output power: 30W for MX30 or 60W for MX60. Failure to respect this may cause permanent damage to the

amplifier.

MIC2 Input

This ¼ '' jack is a two conductor unbalanced microphone input. If you wish to use a low impedance microphone

on a balanced line with a long cable, we recommend that you use an AM-15 adaptor to do so. If you choose to

use a Table Top microphone with an enunciator switch, keep in mind that the switch should be connected to the

two priority terminals.

This special input (terminals 1 and 3) will allow you to page in your PA system using your own telephone set. Pin

2 is Ground and Pin 4 is for manual priority switching. Any signal going through Pin 3 with automatically triggers

the priority system without any manual intervention. At the end of the announcement, the system will return to its

normal operation. A Gain control is located next to the input in order to increase incoming volume if necessary.

Final adjustment will be made with the Tel Paging volume control located on front panel.

Keep your amplifier away from excessive humidity, dust or grease. This unit has sensitive components that can

be affected in a difficult environment. If, at one point during its usage, the fuse on the AC line needs to be

changed make sure that the replacement is of the same value. It is important that you try to identify the reason for

this failure. This will most likely prevent further damage to your amplifier. Any service work on this unit should be

performed by a qualified technician