IKEA NUTID Manuel d'installation et d'utilisation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} IKEA NUTID. IKEA NUTID 46 pages. French door refrigerator
Également pour IKEA NUTID : Manuel d'installation (16 pages), Manuel d'installation (12 pages), Manuel d'instructions de montage (12 pages)
The temperature controls are located at the top front of the
refrigerator or freezer compartments. Your refrigerator has either
Electronic or Digital controls. See the instructions specific to
your model.
IMPORTANT:
The recommended setting should be correct for normal
■
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream
is firm.
Wait 24 hours for your refrigerator to cool completely before
■
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.
If the temperature is too warm or too cold in the refrigerator
■
or freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
Electronic Controls
For your convenience, the temperature controls are preset at
the factory. When you first install your refrigerator, make sure
the controls are still set to the recommended setting as shown.
Recommended Setting "4"
To Turn Off/On:
Press both Minus Sign touch pads repeatedly until a dash (-)
appears in both the refrigerator and freezer displays. Neither
compartment will cool.
Humidity Control (on some models)
The humidity control turns on a heater to help reduce moisture
on the door hinge seal. Use in humid environments or when you
notice moisture on the door hinge seal. The refrigerator uses
more energy when Humidity Control is on.
Press the control to ON when the environment is warm and
■
more humid, or if you notice moisture on the door hinge
seal.
Press the control to OFF to save energy when the
■
environment is less humid.
Adjusting Elcetronc Controls
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the chart below
as a guide.
Press the up or down arrow touch pads to adjust the
temperature. Except when starting the refrigerator, do not
adjust either control more than one setting at a time. Wait 24
hours between adjustments for the temperature to stabilize.
12
Using the Controls
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too
little ice
REFRIGERATOR too cold
FREEZER too cold
Digital Controls
For your convenience, your temperature controls are preset at
the factory. When you first install your refrigerator, make sure
the controls are still set to the recommended set points as
shown.
NOTE: When the power is on, the temperature display shows
the set point temperature of the compartment.
To Turn Your Refrigerator Off/On:
Press the freezer (+) touch pad repeatedly until "OFF"
■
appears in the freezer display. Allow a few seconds for the
refrigerator to shut off. Neither compartment will cool.
Press either the refrigerator or freezer (-) touch pad to turn
■
on the refrigerator.
Adjusting Digital Controls
The REFRIGERATOR control adjusts the refrigerator
compartment temperature. The FREEZER control adjusts the
freezer compartment temperature.
If you need to adjust the temperature in either the refrigerator
or freezer compartment, use the settings listed in the chart as a
guide.
To Adjust Set Point Temperatures:
The first touch of the (+) or (-) touch pad displays the current
temperature set point.
Press the (+) or (-) touch pads until the desired temperature
■
set point is displayed.
NOTE: Except when first turning on the refrigerator, do not
adjust either temperature control more than one setting
at a time. Wait 24 hours between adjustments for the
temperature to stabilize.
ADJUSTMENT:
REFRIGERATOR Control one
setting higher
FREEZER Control one setting
higher
REFRIGERATOR Control one
setting lower
FREEZER Control one setting
lower
Recommended Setting