2KRC P002 Manuel d'assemblage - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage pour {nom_de_la_catégorie} 2KRC P002. 2KRC P002 17 pages. Hyper ep. fun scale racer

Table of Contents

Tail surface installation.......................01-06 Tail plane...................................................01-05

Servo tray......................................07-10 Tail servo mounting.......................................07-11

Receiver mounting...........................19-20 battery mounting..........................................32-36

Servo and battery mounting................24-34

Motor mounting..............................21-29

Spinner and prop..............................26-29 Wing mount.................................................48-49

Ailerons control install........................38-47 C.G. adjust.......................................................51

Tail control wire setup....................................13-17

First install the Stab. In fuse. And mark the edge with

marking tape, then use hobby knife made a line small

hole on the cover surface of cover for ensure when

you glue Stab with Fuse was good.

Find Elevator control horn hole on the Elev. And trim

off covering film as show.

Install the Elevator In the fuse. As the show.

Notice: the control horn hole must same side as the

control wire out let.