IKEA FROSTIG Manuel de l'utilisateur - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} IKEA FROSTIG. IKEA FROSTIG 20 pages. Integrated fridge
Également pour IKEA FROSTIG : Manuel (24 pages), Manuel de l'utilisateur (20 pages), Manuel d'assemblage (20 pages), Manuel d'instruction (24 pages), Manuel (32 pages), Manuel (16 pages), Manuel (48 pages), Manuel (24 pages)

Imprimer la page
IKEA FROSTIG Manuel de l'utilisateur
ENGLISH
Problem
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigera-
tor.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working proper-
ly after making the above checks, contact
the After Sales Centre. You can find the list
at the end of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
Possible cause
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
There is too much water in
the air deflector.
The temperature regulator is
not set correctly.
Solution
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product temperature
decrease to room temperature
before storage.
Decrease the room tempera-
ture.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Clean the air deflector.
Set a higher/lower tempera-
ture.
1. Remove the
screw from
the lamp
cover.
2. Remove the
lamp cover.
3. Replace the
lamp with
one of the
same power
and specifically designed for household
appliances. (the maximum power is
shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light
comes on.
11