Airflow 90001461 Manuel d'installation, d'utilisation et d'entretien - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Airflow 90001461. Airflow 90001461 19 pages.

Imprimer la page
80001028 – Issue 1 10/21

5.0 Operation

Section 5 contains information about the operation of the unit and includes the correct
operation of the potentiometer, speed control and an explanation of the labels that are
present on the unit.
Warning:
FFP2) BEFORE performing service and/or maintenance work.
Danger:
Danger to life due to electric shock. An electric shock can result in
death or serious injury. The unit must be fully isolated from the mains power
supply before all maintenance work and before opening the terminal
compartment!
•
Do not operate the unit without a proper electrical grounding/earthing.
•
Make sure the unit is connected to a power supply with a 30 mA
individual RCD.
•
Always disconnect the unit power supply before performing any service
or maintenance work.

5.1 Operating the Power

The fan is directly controlled by the speed controller (potentiometer). Push the rotary control
inwards to power the unit. The blue LED indicates the unit is running, it is for indication
purposes only. The potentiometer must be pressed in to power on the unit. Switch the switch
down on the back of the unit to engage the plug power supply. One power cable is supplied
with the unit package. Use the power cable to connect the power supply into the black port
at the back.

5.2 Speed Control

Turn the knob of the potentiometer clockwise to increase the speed and the airflow. Turn the
potentiometer anti-clockwise to decrease it. The adjustment levels with power draw and
airflow rates can be seen in section 3.0, Table 3 and 4 of this document. Comfort is intended
to be the everyday operating speeds, and boost for short periods of increased purification
13
Make sure to use protective gloves and a protective mask (min.
Figure 6:Speed control potentiometer
Figure 5:The potentiometer is located on the side of the unit