Century CJW2500X SERIES Manuel du propriétaire - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Century CJW2500X SERIES. Century CJW2500X SERIES 20 pages. Epa approved high efficiency air tight insert

Imprimer la page

Installation

1. Remove all boxes of firebricks and any packaging from inside the appliance.
2. Clean out the masonry fireplace ensuring the ashes are placed in a metal container.
3. Remove or lock open the damper plate in the masonry fireplace.
4.
Contact local building, fire officials or authorities having jurisdiction about permits, restrictions
and installation inspection requirements in your area.
5. The insert must be installed in compliance with the minimum clearances to combustible
constructions and floor protection stated on appliance certification label (located on back of unit)
and listed below. See page 5 for further instructions about floor protection.
FAILURE TO FOLLOW THESE MINIMUM CLEARANCE REQUIREMENTS MAY RESULT IN AN
UNSAFE INSTALLATION.
6. Install the refractory bricks (see page 10).
7. Install faceplate onto inser
fireplace. If this is not a good fit, a 2"(50mm) wide strip of fibreglass insulation can be used to
insure a good fit.
A
UNIT TO SIDE WALL
UNIT TO TOP TRIM
B
C
UNIT TO SIDE TRIM
D
UNIT TO MANTEL
FLOOR PROTECTOR FRONT
E
FLOOR PROTECTOR SIDE
F
t (see pages 9 and 11)
CLEARANCE TO COMBUSTIBLE CONSTRUCTIONS
**See Floor protection requirements, next page
MANTLE
TOP TRIM
FACE PLATE
FLOOR PROTECTOR
A
. The trim should fit against the face of the
12" (305mm)
10" (255mm)
10" (255mm)
17" (430mm)
16" (405mm) IN THE US
18" (457mm) IN CANADA
8" (200mm)
B
C
F
4
12"
(305mm)
MAX
D
E
FLOOR