Century K3150-1 Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Century K3150-1. Century K3150-1 18 pages. Wheel charger 11860 40/20/2/200, 6/12v w/test 11861 60/40/2/250, 6/12v w/test 11862 60/40/30/225, 6/12/24v

Imprimer la page

ASSEMBLY OF HANDLE AND CLAMP

HOLDER

Assemble the charger handle and clamp holder accord-

ing to the following instructions and illustrations.

1. Carefully remove the charger unit and all associated

hardware from carton, note the charger is shipped

with the handle partially secured, and resting in a

down position on the front of the unit.

2. Unscrew the top 2 screws on either side of the

charger. Remove the bottom 2 screws holding han-

dle with the washers (washers will be discarded), as

shown in Figure 1 .

FIGURE 1

REMOVE AND DISCARD

2 WASHERS

TOP

2 SCREWS

BOTTOM

2 SCREWS

HANDLE

3. Then replace the bottom 2 screws by screwing in part

way so the handle can be move to an upright posi-

tion. (See Figure 2)

FIGURE 2

REPLACE BOTT OM

2 SCREWS BY

SCREWING IN

PART WAY

4. Align the holes of the handle with the top 2 screw

holes of the charger. Replace the top 2 screws which

you removed in Figure 1. Tighten all 4 screws secur-

ing the handle in the upright position. (See Figure 3)

ASSEMBLY

ROTATE HANDLE

TO UPRIGHT

POSITION

FIGURE 3

REPLACE TOP

2 SCREWS THEN

TIGHTEN ALL 4

SCREWS

5. Carefully screw the clamp holder together onto the

handle as shown in Figure 4.

FIGURE 4

CLAMP HOLDER

SCREWS

HANDLE