decoflame Orlando e-Ribbon Fire Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} decoflame Orlando e-Ribbon Fire. decoflame Orlando e-Ribbon Fire 7 pages.

Imprimer la page

OrlanDO e-rIbbOn™ FIre

Orlando Installation

Decoflame bluetooth application Installation

1. Download and install the Decoflame

app by scanning the Qr code above cor-

responding to your smart device's operat-

ing system.

4. Once you have selected your fireplace,

you can turn it on by pressing 'sTarT'. If the

fireplace has already been turned on us-

ing the display, you can now monitor the

fuel leven and the consumption.

2. In order to pair your fireplace with your

smart device, start the fireplace by press-

ing 'On' button and insert the code high-

lighted above.

Note: The code will appear only for a few seconds.

Make sure that you write it down or take a picture

of it.

5. For the 'Turn Off Timer' press the clock

icon in the lower right corner. To adjust the

remaining time, slide the dot to the left and

right and select 'seT TImer'. The remainig

burning time can be changed by repeating

the above mentioned steps. To cancel the

timer select 'clear TImer'.

www.decoflame.com

step 1: make sure that the dimensions of

the cut-out correspond to the measure-

ments indicated in the technical drawing

received with your fireplace. also be sure

the is no draft inside the wall.

step 2: recess the fireplace casing into

the wall cut-out according to the indica-

tions in the user's manual.

step 3: connect the burner to a source

of electricity.

step 4: carefully lower the burner with

baseplate in place and fit the frame. at-

tach with screws

step 5: If the case, place the glass screen

on the top plate by fitting the pin holders

into the holes.

Step 6: Turn on the display. Fill in the right

amount of bioethanol by verifying the

level on the display.

step 7: start the fireplace by pressing the

On icon on the display.

. Once your device is paired, the fireplace

should be visible on the app. You are now

able to change the name of the fireplace.

Note: You are able to pair more than one fireplace

like described in the step nr. 2 and give them differ-

ent names.

6. For adjusting the flame intesity, select

the desired level on the left side of the

screen. (1-lowest, 6-highest)

should there not be enough fuel for the se-

lected burning time - the fireplace will shut

down automatically.

select 'sTOP' tu turn off the fireplace.

Decoflame Technical Information