IKEA TILLREDA Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} IKEA TILLREDA. IKEA TILLREDA 12 pages. Portable
Également pour IKEA TILLREDA : Manuel (16 pages), Manuel d'instructions d'installation (36 pages), Manuel (48 pages), Manuel (48 pages), Manuel (32 pages), Manuel (48 pages), Manuel (40 pages), Manuel (48 pages), Manuel (44 pages), Manuel (20 pages), Manuel (16 pages), Manuel (32 pages), Manuel (44 pages), Manuel (24 pages), Manuel (36 pages), Manuel (8 pages), Manuel (36 pages), Manuel (44 pages), Manuel (33 pages)

Imprimer la page
IKEA TILLREDA Manuel
6

Operation

Switching on
Insert the plug into the wall socket. Turn
the temperature regulator clockwise to a
medium setting.
When operating the refrigerator for the first
time, run it without loading any food until
it autos tops at the desired temperature.
Usually it takes 2 or 3hours,then set the
thermostatic dial at the setting desired and
put foods in the refrigerator.
Switching off
To turn off the appliance, turn the
temperature regulator to the "OFF" position.

First Use

Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and same neutral soap
so as to remove the typical smell of a brand-
new product, then dry thoroughly.

Daily Use

Accessories
Defrosting tray
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
•
turn the temperature regulator toward
lower settings to obtain the minimum
coldness.
•
turn the temperature regulator toward
higher settings to obtain the maximum
coldness.
A medium setting is generally the most
suitable.
However, the exact setting should be chosen
keeping in mind that the temperature inside
the appliance depends on:
•
room temperature
•
how often the door is opened
•
the quantity of food stored
•
the location of the appliance.
Important! If the ambient temperature is
high or the appliance is fully loaded, and the
appliance is set to the lowest temperatures,
it may run continuously causing frost to
form on the rear wall. In this case the dial
must be set to a higher temperature to
allow automatic defrosting and therefore
reduced energy consumption.
Important! Do not use detergents or
abrasive powders, as these will damage the
finish.
ENGLISH