Gantner GAT Info 6100 Manuel de démarrage rapide - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Gantner GAT Info 6100. Gantner GAT Info 6100 4 pages. Information terminal
Également pour Gantner GAT Info 6100 : Instructions d'installation (4 pages)
Imprimer la page
Mounting and installation instructions
The back part of the device attaches to a flat surface (e.g., concrete wall)
using screws. When attaching to an uneven surface the device back part
must not be distorted as this prevents the correct connection of the device
front part. Recommended mounting height = 1.3 m (top edge of device).
Use the drilling template that is attached to the device.
69 mm (2.72´´)
60 mm (2.36´´)
1
2
13 mm (0.51´´)
Mounting the device front part
Once the connection cables are terminated, the device back part and front
part are connected together via a connection cable (delivered already
connected in the front part) and the two parts are fixed together.
1.
Notes:
1. Check the socket in the device back part (circled in figure 1). Any dirt,
dust and moisture must be removed to ensure correct operation. Do
not use any aggressive detergent and take care not to damage the
socket contacts if cleaning is required.
Attention: Only clean the device in powerless state.
2. Plug in the connection cable into the socket on the device back part
(consider alignment) and clip the top of the device front part into the
device back part.
www.gantner.com
Wall mounting
Cabling can be flush mounted (1) or surface mounted (2).
When surface mounting the cabling, ensure they can still be inserted once
the device back part has been mounted. Otherwise run the cables through
the cable lead-ins prior to securing.
4
1. Flush-mounted cable
2. Surface-mounted cable
3
3. Back box
4. Device back part
5. Cable conduit for surface cable connection
5
2.
3. Swing down the device front part until it clicks into place.
4. The device can only be opened using the supplied special tool! With
Valid as from February 15
3.
the tool, the two catches on the bottom of the device are released in
succession.
2016 • Technical data subject to modifications without notice!
th
DB_GAT-INFO6100--EN_11.indd • PartNo.: 860380
4.
3