Britax ROADSTER 2 IN 1 WALKER Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Britax ROADSTER 2 IN 1 WALKER. Britax ROADSTER 2 IN 1 WALKER 6 pages.

INSTALLING THE UPPER SEAT FRAME

NOTE: At the top of each support leg, you will notice a spring loaded pin.

The Seat frame needs to be locked onto each of

the spring loaded pins.

Locate the Seat frame cavities over the support legs.

Press down on the Seat frame until both sides lock

onto the pins.

Pull up on each side to make sure the Seat frame

is locked onto the support legs. If not locked repeat

steps.

INSTALLING AND ATTACHING THE SOFT SEAT TO THE SEAT FRAME

NOTE: The soft seat must be secured to the frame by the webbing straps.

Firstly, raise the plastic backrest support up and lock it into position.

Position the soft seat onto the seat frame by lowering the soft seat pocket

over the plastic moulding.

One by one, thread each of the webbing straps through the locating holes

in the seat frame.

From the underside, pull the webbing straps all the way through until the

plastic moulding locks through the hole.

Pull up on the soft seat to make sure all webbing straps are locked into the

Seat frame. If not, repeat D.

BOUNCE FUNCTION

NOTE: The Walker has one Bounce function & 3 height adjusting positions.

BOUNCE MODE:

If the support legs are locked into a fixed

height position, by pushing in the RED

buttons and turning them towards the

Jump indicator, this will put the support

legs into Bounce mode.

The Bounce mode will sit in the highest

seat position,'1' , when not locked.