Gantom TL281 Manuel de l'utilisateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Gantom TL281. Gantom TL281 10 pages.
Imprimer la pageSafety and Operation notes:
Please carefully review the following safety notes regarding the Gantom Juni micro gobo projector.
These notes are important for safe installation and usage of the product.
Do not look directly at the light source while the fixture is powered on.
Inspect all power cables for damage or crimped cable before use.
Make sure that your circuit is properly grounded and all electrical safety precautions have been
taken to prevent electric shock.
Be aware that the fixture will become HOT to the touch when it is left on.
Allow several minutes for the light to cool before touching it after extended periods of on time.
Ensure that there are no flammable materials close to or in contact with the light fixture.
Never touch the lenses within the fixtures. If the lenses must be cleaned, use a microfiber cloth
and glasses cleaning solution.
Make sure that the locking cable connectors are fully tightened when the product is installed.
Check the voltage of the power line before connecting the fixture to ensure that it is within the
required range for the fixture.
In the event of a serious operating problem, cut power to the fixture and cease operation
immediately.
For technical support, please contact
426-8661).
The Gantom Juni micro framing projector comes with an aluminum mounting yoke pre-installed. It is
meant to be used with ¼" size hardware, but please note that mounting hardware is not included with
the fixture. The yoke has a center hole (1) and a curved slot (2). Install a screw in the center hole first,
then loosely screw down a second screw through the curved slot. Rotate the fixture to the appropriate
angle and then finally tighten down both screws all the way to lock the fixture in place.
MOUNTING INSTRUCTIONS
Gantom Juni User Guide
or call 1-855-GANTOM1 (1-855-
Version 1.0 – 3/31/2021