GREEN LOO SCANDI-POD Manuel de démarrage rapide - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} GREEN LOO SCANDI-POD. GREEN LOO SCANDI-POD 8 pages.

Drill a suitable hole in the wall to allow the vent pipe to traverse through the wall. Suggested installation

drawing below. After the vent system has been installed, seal wall hole with silicone.

Vent Pipe Installation

The ventilation pipe should rise perpendicularly with as few curves and elbows as possible, the vent cowl

placed on top. Don't use pipe cement – the push fittings should be tight enough for this purpose, and this allows

you to dismantle and service the vent system as required.

The below is an example as to a standard vent installation – there are many permutations possible and if in

doubt, contact us for discussion and guidance:

1. Cut off a short piece of vent pipe and cut off a 45 degree piece, about half the pipe diameter. The length

of this pipe is to allow the fan to be affixed without interfering with the turning mechanism for the

bulking material spreader. The 45 degree cut off is to be the at the bottom of this pipe, facing inwards,

to make exchange of composting containers easier.

2. Attach the fan (supplied), and cut off a short piece of the vent pipe and insert into the fan. Plug the fan

into the power supply (supplied) or 12V system and ensure the airflow is away from the composting

container, upwards towards the exhaust end.

3. Attach the 45 degree bend (supplied), pointing backwards. Cut a hole in the wall, allowing the vent pipe

assembly to traverse the wall. Cut a short piece of pipe to traverse the wall.

4. Moisture trap: Attach the Y joiner (supplied) as per the picture. Cut off a short piece of vent pipe and

insert into the Y – joiner at the bottom. Finish with attaching the cap (supplied). This is your moisture