IKEA IH3302WQ0 Manuel d'utilisation et d'entretien - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} IKEA IH3302WQ0. IKEA IH3302WQ0 24 pages. 30" (76.2 cm) and 36" (91.4 cm) range hood installation instructions

Imprimer la page

Parts needed

For direct wire installation

•

UL listed or CSA approved 1/2"(12.5 mm) strain relief

•

75-watt max incandescent

light bulb

•

Power supply cable (if needed, for direct wire installation)

For power supply cord installation

•

UL Listed Power Supply Cord Connection

Kit marked for

range hood use.

•

75-watt max incandescent

light bulb

For vented installations you also need:

•

31/4 '' x 10" (8.3 x 25.4 cm) or 7" (17.8 cm) round metal venting

•

7" (17.8 cm) round damper, if using 7" (17.8 cm) round vent

system

For cabinets with recessed bottoms:

•

Two 2" (5.1 cm) wide filler strips. Length and thickness

determined

by recess dimensions.

•

Four flat head wood screws or machine screws with washers

and nuts (to attach filler strips).

IMPORTANT:

Observe all governing codes and ordinances.

•

It is the installer's responsibility

to comply with installation

clearances specified on the model/serial rating plate. The

model/serial

rating plate is located inside the range hood on

the rear wall.

•

Range hood location should be away from strong draft areas,

such as windows, doors and strong heating vents.

•

Cabinet opening dimensions that are shown must be used.

Given dimensions

provide minimum clearance. Consult the

cooktop/range

manufacturer

installation instructions

before

making any cutouts.

•

Grounded electrical outlet is required. See "Electrical

Requirements"

section.

•

The hood is factory-set for vented installations. For non-

vented (recirculating) installations,

charcoal filter pad Part

Number 4396846 is available from your dealer.

•

All openings in ceiling and wall where range hood will be

installed must be sealed.

For Mobile Home Installations

The installation of this range hood must conform to the

Manufactured

Home Construction

Safety Standards, Title 24

CFR, Part 328 (formerly the Federal Standard for Mobile Home

Construction

and Safety, title 24, HUD, Part 280) or when such

standard is not applicable, the standard for Manufactured

Home

Installation 1982 (Manufactured

Home Sites, Communities

and

Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local

codes.

Product Dimensions

t 1/2"

(2.5 cm)

6"i

(15.2cm)

"---.(19.1 cm)

29 T/s"(75.9 cm) - 30" (76.2 cm) model

35 T/s"(91.1 cm) - 36" (91.4 cm) model

17W'

. (44.5cm)

Installation Clearances

openmc

18" (45.7 cm) min.

24" (61.0 cm)

suggested

max.

bott-om of cabinet

g surface

18" (45.7 cm)

rain. clearance

upper cabinet

to countertop

36" (91.4 cm)

base cabinet

height