IKEA IHW6530BS0 Manuel d'utilisation et d'entretien - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} IKEA IHW6530BS0. IKEA IHW6530BS0 44 pages. 30" (76.2 cm) wall-mount canopy range hood

Imprimer la page

1. Remove screws from wooden shipping supports. Properly

dispose of shipping materials.

2. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

D. Optional wall anchors (if needed)

3. Remove the grease filter. See "Range Hood Care" section.

4. Level the range hood and tighten upper mounting screws.

5. Install 2 - 5 x 45 mm #2 Phillips lower mounting screws and

tighten. (Use optional wall anchors if needed.)

Install transition on top of hood (if removed for shipping) with

2 - 3.5 x 9.5 mm T10 sheet metal screws. Use T10 Torx ®drive

(or T10 adapter provided) to tighten.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket using

4 - 4.2 x 8 mm T20 ®screws. Use T20 ®Torx ®drive (or T20 ®

adapter provided) to tighten.

A. Assembly

screws

B. Air deflector

C. Duct cover bracket

Measure from the bottom of the air deflector to the bottom of

the hood outlet.

A.Air deflector

D. Vent duct

B. Ventclamp

E. Exhaust outlet

C. X = length to cut vent duct

3. Cut the duct to the measured size (X).

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket with

the 4 assembly screws.

8. Seal connections

with vent clamps.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over the exhaust outlet.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.