IKEA KULINARISK Manuel d'instructions d'installation - Page 25

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} IKEA KULINARISK. IKEA KULINARISK 36 pages. Oven with steam feature
Également pour IKEA KULINARISK : Manuel d'instruction (20 pages), Manuel de l'utilisateur (36 pages), Manuel de l'utilisateur (16 pages), Manuel de l'utilisateur (36 pages), Manuel de l'utilisateur (32 pages), Manuel (36 pages), Manuel d'instruction (48 pages), Manuel d'instructions (36 pages), Manuel (24 pages), Manuel (20 pages), Manuel (44 pages), Manuel de l'utilisateur (36 pages), Manuel (40 pages), Manuel (40 pages), Manuel de l'utilisateur (20 pages), Manuel (37 pages), Manuel (32 pages), Manuel de démarrage rapide (16 pages), Manuel (20 pages), Manuel (20 pages), Manuel (36 pages), Manuel (21 pages), Manuel de démarrage rapide (8 pages), Manuel (40 pages), Manuel (20 pages), Manuel (32 pages), Manuel (36 pages), Manuel (17 pages)

ENGLISH

2. Fully press the clamping levers (A) on

the two door hinges.

3. Close the oven door to the first opening

position (approximately 70° angle).

4. Hold the door with one hand on each

side and pull it away from the appliance

at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface. This

is to prevent scratches.

6. Hold the door trim on the top edge of

the door at the two sides and push

inwards to release the clip seal.

7. Pull the door trim to the front to remove

it.

8. Hold the door glass panels on their top

edge one by one and pull them up out

of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, install the

glass panels and the oven door. Do the

above steps in the opposite sequence.

Make sure that you put the glass panels (A

and B) back in the correct sequence. The

first panel (A) has a decorative frame. The

screen-printing zone must face the inner

side of the door. Make sure that after the

installation the surface of the glass panel

frame (A) on the screen-printing zones is

not rough when you touch it.

Replacing the lamp

Put a cloth on the bottom of the interior of

the appliance. It prevents damage to the

lamp glass cover and the cavity.

Warning! Danger of

electrocution! Disconnect the fuse

before you replace the lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box or

deactivate the circuit breaker.