Bernee BN-5606H3/M3 series Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Bernee BN-5606H3/M3 series. Bernee BN-5606H3/M3 series 11 pages. Integrated speed dome cameras

Imprimer la page

EMBEDDED DOME INSTALLATION

Step 1: drill a hole on ceiling

At the installation center of ceiling drill a hole of

3 m m d i a m e t e r, i n p u t s e l f - t r a p p i n g s c r e w t o

positioning-ruler hole, and then fix it on ceiling.

Use pencil and positioning-ruler drawing a circle,

dig away stuff.

Step 3: set dome

Set dome bottom DIP switcher (SW1 and SW2) to

confirm control-protocol and dome address, similar

with label setting or switcher setting.

Step 5: install dome

Insert 3 screw units into the

upper bracket hole, just like the

picture directing, confirm all

screws are tightened in locating

slot.

Turn

CEILING MOUNT DOME INSTALLATION

Step 1: open hole on ceiling

According to bracket hole size, use pencil and

positioning-ruler drawing a circle (Φ40mm), dig away

stuff.

At the edge of circle, drill 3 holes (Φ6mm) matched

with 3 holes of bracket, then fill M6 anchor-screws on

each hole (anchor-screws are offered by customer).

AC 1

Power supply

GND

24VAC

AC 2

Monitor or other

video-input

devices

Video out

Control signal

RX+

RS-485(Pelco)

RX-

Step 2: install embedded bracket

Press embedded-bracket fixture, input fixture input

hole of ceiling until wholly entering. Unwrap the three

fixtures, tighten screw, and confirm that embedded-

bracket has already been fixed on ceiling.

Notes: embedded-bracket and ceiling must link

with steel belt so as to avoid dome dropping. The steel

belt should be offered by customer.

Step 4: connect to mechanical module wiring

Power line

Video line

Control line

Step 2: fix ceiling-mount bracket

Insert anchor-screws to 3 holes and fasten them

with pad & nut.

- 5 -

Connect video cable,

power line and control line with

mechanical module. As picture

directing.