CEP HT63 E Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} CEP HT63 E. CEP HT63 E 20 pages.

Electrical Description

The modem uses the following standard connectors:

 RJ11 6-way (power connector)

 Mini USB (USB 2.0)

 SIM card reader

 FME male coaxial jack (antenna connector)

 Sub-D female socket, 9 pin (RS232 serial port)

An RJ11 6-way connector, as shown and described below, serves as a means of supplying and

controlling DC power to the modem. It is necessary to connect an external power supply, since

the available power on the USB port is not sufficient to run the modem.

The supply voltage, VCC, required by the modem is 5V - 32V DC. Application of the supply

voltage does not switch the modem on. To do so an additional active-high control signal,

TO_IN, must be applied for > 1 second.

Please see chapter "3.1 Switching ON the modem" for further important details about TO_IN

and power supply requirements, especially if TO_IN is applied in parallel to VCC.

VCC and GND are reverse-polarity and over-voltage protected.

This does not apply for the GND on the antenna connector if this coax GND /

shield are connected to your applications ground-plane.

6 5 4 3 2 1

Figure 4: RJ11 Pin Connector