HIKVISION Turbo HD DS-2CE5AD8T-VPIT3ZE Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HIKVISION Turbo HD DS-2CE5AD8T-VPIT3ZE. HIKVISION Turbo HD DS-2CE5AD8T-VPIT3ZE 17 pages. Turbo hd dome camera
Également pour HIKVISION Turbo HD DS-2CE5AD8T-VPIT3ZE : Manuel de l'utilisateur (12 pages)
Imprimer la page
2 Installation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your required output to avoid damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera and the
mounting.
If the wall is cement, insert expansion screws before
installing the camera. If the wall is wooden, use
self-tapping screw to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Ceiling Mounting of Type I/Type II Camera
Before you start:
The installation steps of Type I and Type II Camera are
similar and the following takes Type I as an example to
describe the steps.
Steps:
1. Paste the drill template to where you want to install
the camera.
2. Drill screw holes and the cable hole (optional) on
the ceiling according to the drill template.
Note:
Drill the cable hole (hole A) when adopting the wall
outlet to route the cable.
3. Loosen the screws to remove the bubble.
4. Secure the back box on the ceiling with four PA4 ×
25 screws.
Figure 2-1 The Drill Template
Figure 2-2 Remove the Bubble