Green Power GNLS05T-1020H Manuel du propriétaire - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Green Power GNLS05T-1020H. Green Power GNLS05T-1020H 14 pages. 5 ton log splitter

Imprimer la page

SHARPENING WEDGE

After using the log splitters for some time, sharpen the wedge of the log splitter using a

fine-toothed file and smooth any burrs or crushed area along the cutting edge.

TROUBLE SHOOTING

PROBLEM

Motor Stops to

Start

Fails to split logs

The log pusher

moves

jerkily,

taking

unfamiliar

noise or vibrating

a lot

Oil leaks around

cylinder ram or

from other points.

PROBABLE CAUSE

Overload

Protection

disengaged to protect the log

splitter from being damaged

Log is improperly positioned

The sizes or hardness of the log

exceeds the capacity of the

machine

Wedge cutting edge is blunt

Oil leaks

Unauthorized adjustment

made on

Max. Pressure Limiting

Screw. Lower max pressure rating

was set.

Lack of hydraulic oil and excessive

air in the hydraulic system.

Air sealed in hydraulic system while

operating.

Bleed Screw is not tightened before

moving the log splitter.

Oil Drain Bolt with Dipstick is not

tight.

Hydraulic Control Valve Assembly

and / or seal(s) worn

REMEDY SUGGESTED

Device

Contact a qualified Electrician for opening

the Pushbutton Box to engage the Overload

Protection Device inside *

Refer to " Log Splitter Operation" section for

perfect log loading.

Reduce the log sizes before splitting it on

the log splitter

Refer to " Sharpening Wedge " section to

sharpen the cutting edge.

Locate leak(s) and contact the dealer

was

Contact the dealer.

Check oil level for possible oil refilling.

Contact the dealer.

Loosen Bleed Screw by 3 ~ 4 rotations

before operating the log splitter

Tighten the Bleed Screw up before moving

the log splitter.

Tighten the Oil Drain Bolt with Dipstick.

Contact the dealer