KitchenAid DISHWASHER Instructions pour l'utilisateur - Page 4
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} KitchenAid DISHWASHER. KitchenAid DISHWASHER 10 pages. Drawer dishwasher
Également pour KitchenAid DISHWASHER : Manuel d'instructions d'installation (6 pages), Instructions pour l'utilisateur (20 pages), Instructions pour l'utilisateur (5 pages)
Imprimer la page
Depending on your water hardness, fill the Main Wash section
of the dispenser as shown. Fill the Pre-Wash section to the
level shown, if needed.
NOTE: Fill amounts shown are for
standard powdered detergent.
Follow instructions on the
package when using other
dishwasher detergent.
Powdered detergent is recommended for use in the drawer
dishwasher.
Add Rinse Aid
Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid, your dishes and dishwasher
interior will have excessive moisture.
Rinse aid keeps water from forming droplets that can dry as
spots or streaks. They also improve drying by allowing water to
drain off of the dishes after the final rinse.
Rinse aid helps to reduce excess moisture on the dish racks
and interior of your dishwasher.
When the dispenser is low and needs to be
refilled, an indicator light on the control panel
will illuminate.
To add rinse aid, turn
the dispenser cap a ¹⁄₄
turn counterclockwise
and remove. Pour
rinse aid into the
opening until the liquid
reaches the FULL
level marking. Replace
the dispenser cap and
turn clockwise until
the cap is secure.
NOTE: For most water conditions, the factory setting of 3 will give
good results.
4
Hard Water
Hard Water
Soft Water
Soft Water
Pre-Wash
Main Wash
¹⁄₄
turn to lock
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 2¹⁄₂ hours to complete.
For models with Cycle Select, pressing the Cycle Select button will
illuminate the light above the cycle. With each press of Cycle
Select, you will increment the cycle selection. To choose a cycle,
press the Cycle Select button until the light above is illuminated.
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired. To
Cancel an option, press it again.
Start or Resume a Cycle
Prior to starting the dishwasher, run the water at the
sink until it is hot. This will ensure the water is hot
when it enters the dishwasher when it is started.
Make sure to turn the sink water off.
Select the wash cycle and options desired.
Press START/RESUME button once and close the drawer. After
a brief pause, the cycle will begin. The drawer must be closed
within 4 seconds after pushing START/RESUME or the lights
will flash, a tone will sound, and the dishwasher will not begin.
Press the START/RESUME button again and shut the drawer
within 4 seconds.
You can add an item anytime before the main wash starts.
Open the drawer slowly and add the item. Press the START/
RESUME then close the drawer.
NOTE: If you have a two drawer dishwasher model, each drawer
has its own controls and can run independently of the other.
STEP 3
STEP 4