HIKVISION TURBO HD TVI DS-2CE16D0T-IRPE Manuel de l'utilisateur - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HIKVISION TURBO HD TVI DS-2CE16D0T-IRPE. HIKVISION TURBO HD TVI DS-2CE16D0T-IRPE 15 pages. Turbo hd tvi bullet & turret camera
Également pour HIKVISION TURBO HD TVI DS-2CE16D0T-IRPE : Manuel de l'utilisateur (17 pages)
Imprimer la page
1). Loosen the No.1 adjusting screw to adjust the
pan position (0° to 360°).
2). Tighten the No.1 adjusting screw.
3). Loosen the No.2 adjusting screw to adjust the
tilting position (0° to 180°).
4). Tighten the No. 2 adjusting screw.
5). Loosen the No.3 adjusting screw to adjust the
rotation position (0° to 360°).
6). Tighten the No.3 adjusting screw.
2.4
Installation of Type II camera
Before you start:
Both wall mounting and ceiling mounting are suitable
for the turret camera. Ceiling mounting will be taken as
an example in this section. You can take the steps of
ceiling mounting as a reference, when adopting wall
mounting.
Steps:
1. Disassemble the turret camera by rotating the
camera to align the notch to one of the marks, as
shown in Figure 2. 1.
Figure 2. 7 Disassemble the Camera
2. Remove the mounting base from the camera body
with a flat object, e.g., a coin.
3. Paste the drill template (supplied) to the place
where you want to install the camera, and then drill
the screw holes and the cable hole (optional) on the
ceiling according to the drill template.
Note:
Cable hole is required when adopting the ceiling
outlet to route the cable.
4. Attach the mounting base to the ceiling and secure
them with supplied screws
Figure 2. 8 Drill Template
Mark
Notch