KitchenAid KDC-38 Manuel d'instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid KDC-38. KitchenAid KDC-38 6 pages.

Imprimer la page
IMPORTANT:
Read
Before
Installing
to Save Time,
Work,
assure
proper
performance,
and
owner's
warranty
protection.
ELECTRICAL
SPECIFICATIONS
Voltage & Frequency
---
115 volts-60
hertz
Operating
load
-------
13.5 amperes - KDS-38
7.9 amperes - KDC-38
Maximum
Fuse Size ----
15 amperes
CAUTION:
Avoid
getting
white
lead or lubricant
inside new joints.
Hot water fill line must be flushed
of foreign
matter
before connection
to dishwasher
fill valve. A hand shut off valve (not furnished)
should
be located
in an easily accessible area adjacent to the
dishwasher.
Wiring
must
conform
to local
code and/or
Nat.
Electrical
Code.
Plumbing
must conform
to local code. Use l/2"
O.D.
ature at dishwasher
should
be 140°F.
to 160°F.
A
(min.)
copper
tube
for water
line. Dishwasher
has
5/8" I.D. drain hose is furnished
for connection
to an
318"
I.P.S.
Internal
thread
at
valve.
A
90"
air gap, waste disposer or the Drain '7."
Drain "T"
is
compression
ell
(furnished)
should
be
used
to
furnished.
Air Gap and Rinse Agent Kit accessories,
connect
tubing
to
valve.
Water
flow
pressure
at
if required,
are available
from your dealer or distrib-
dishwasher
to be 20 PSI to 120 PSI. Water temper-
utor.
INSTALLATION INSTRUCTIONS
0
1
Locate
top of lower
panel just below
evaporation
channel
support.
Insert
panel
flange
under
evaporation
channel
support
ends "A"
and push up to engage top of panel. Lift
up lower bottom
flange of panel, place flange "B" over frqnt
face of frame and push in. Assemble lock washer "D"
under
head of one screw to ground
dishwasher.
Fasten panel with
two screws "C"
furnished.
If a wood or laminate
front
is to
be used and these panels are not immediately
available,
use
back-up
panel furnished
with
trim
kit. Stainless
steel trim
should be used to assemble wood or laminate
when available.
Reverse procedure
when removing
lower panel.
0
2
To establish
a reference
line for purposes of
providing
plumbing
and electrical
connections
to the dishwasher,
measure 21" from the wall.
(This
is the front
edge of dishwasher
kick
panel. There is a 3" toe space from the front
of the kick
panel to the front
edge of the
dishwasher
with
a standard
metal
front
panel).
For corner installation,
allow 2" clear-
ance for adjacent cabinet.
SHADED AREA SHOULD
BE FREE
OF ALL PLUMBING
AND ELECTRICAL CONNECTIONS
SINK
CABINET