KitchenAid KDTM354DSS Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} KitchenAid KDTM354DSS. KitchenAid KDTM354DSS 17 pages.
Imprimer la page
Control
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's started.
To turn the audible
tones on or off.
The Cycle Status
Indicator Lights are
used to follow the
progress of the
dishwasher cycle.
The Cycle Status
Display is used to
follow the progress of
the dishwasher cycle,
and to show other
information.
Cleaning the Dishwasher
Clean the exterior of dishwasher with a soft, damp cloth and mild
detergent. If your dishwasher has a stainless steel exterior, a stainless
steel cleaner is recommended - Stainless Steel Cleaner and Polish Part
Number 31462A.
Removal of Hard Water / Filming: It is recommended to use a
monthly maintenance product such as affresh
Part Number W10282479.
Load your dishwasher (preferably with dishes affected by filming /
hard water).
Place tablet in main wash compartment of detergent dispenser.
Select cycle/option best for heavily soiled dishes and start
dishwasher.
NOTE: It is recommended to use a premeasured detergent tablet or
pack for regular daily use.
Purpose
Press and hold CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle After Dishwasher Is Started" and "Changing A Cycle After Dishwasher
Is Started" sections in the full User Guide.
Press and hold the Hi-Temp Wash button for 3 seconds to turn the audible tones on or off. Only
audible tones for confirming button presses can be turned on/off. Important audible tones, such
as indicating a cycle has been interrupted, cannot be deactivated.
The Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the Sanitized
indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the
end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to
the required temperature.
The Clean and Sanitized lights go off when you open and close the door or press and hold
CANCEL.
The indicators will inform you if you are able to add a dish to the cycle after it has started. It will
also inform you if the dishwasher is washing, rinsing, drying, complete, and/or sanitized. They
will show whether the control is locked and/or the delay option is selected. A series of bars will
count down the duration of the cycle remaining from left to right. Each bar equals
approximately 24 minutes of cycle length. The bars will also count down the delay feature from
left to right, and the delay indicator will be activated.
After every 30 cycles, the dishwasher will display "affresh," providing a temporary reminder for
you to perform a monthly maintenance procedure. See "Dishwasher Care" section.
DISHWASHER CARE
®
Dishwasher Cleaner
Comments
If you have a drain air gap, check
and clean it if the dishwasher isn't
draining well.
To Reduce Risk of Property Damage During Vacation or Extended
Time Without Use
When you will not be using the dishwasher during the summer
months, turn off the water and power supply to the dishwasher.
Make sure the water supply lines are protected against freezing
conditions. Ice formations in the supply lines can increase water
pressure and cause damage to your dishwasher or home. Damage
from freezing is not covered by the warranty.
When storing your dishwasher in the winter, avoid water damage by
having your dishwasher winterized by authorized service
personnel.
6