IKEA tradfri Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} IKEA tradfri. IKEA tradfri 24 pages. Motion sensor
Également pour IKEA tradfri : Manuel de l'utilisateur (36 pages), Manuel d'instructions de montage (36 pages), Manuel d'instructions de montage (24 pages), Manuel (12 pages), Manuel (28 pages), Manuel (20 pages), Manuel (16 pages), Manuel (20 pages), Manuel rapide (36 pages), Manuel (16 pages), Manuel (32 pages), Manuel (12 pages), Manuel (8 pages), Manuel (24 pages), Manuel (24 pages), Manuel (32 pages), Manuel (24 pages), Manuel (32 pages), Manuel (32 pages), Manuel (24 pages), Manuel (12 pages), Manuel (24 pages), Manuel (24 pages), Manuel (29 pages), Manuel (12 pages), Manuel de démarrage rapide (12 pages), Manuel (40 pages), Manuel de démarrage rapide (24 pages), Manuel de démarrage rapide (16 pages), Manuel (16 pages), Manuel (24 pages), Manuel (32 pages), Manuel de démarrage rapide (2 pages), Manuel (40 pages), Manuel de démarrage rapide (16 pages), Manuel (36 pages), Manuel (28 pages), Manuel de démarrage rapide (2 pages), Manuel (32 pages), Manuel (32 pages), Manuel (24 pages), Manuel d'instructions (8 pages), Manuel (24 pages), Manuel de démarrage rapide (4 pages), Manuel (8 pages), Manuel (20 pages), Manuel (12 pages), Manuel (8 pages), Manuel (32 pages), Manuel de démarrage rapide (4 pages), Manuel (48 pages)

Imprimer la page
IKEA tradfri Manuel

ENGLISH

FUNCTIONS MOTION SENSOR
Day/Night setting. During the daytime the
lights will always turn on when triggered by
motion. At night the lights will only turn on
when it is dark and they are triggered by
motion.
The light sources connected to the motion
sensor can be easily set at either 30% or
100% brightness.
Button for pairing. Add IKEA Smart lighting
products to your system. Follow the
instructions below:
ADDING DEVICES TO YOUR
MOTION SENSOR
Before you can use your motion sensor it must
be paired to the light source you want to steer.
If you want to add more light sources, just
repeat the steps below for each individual light
source.
1 Make sure that your light source is installed
and the power is turned on.
2 Hold the motion sensor close to the light
source you want to add (no more than 5 cm
away).
3 Press and hold the pairing button
least 10 seconds. A red LED light will shine
steadily on the rear side of the motion
sensor.
4 Your light source will flash one time to
indicate that it has successfully paired.
Up to 10 light sources can be paired with 1
motion sensor.
Make sure to pair them one at a time. If the
light sources are close to each other, disconnect
those that have already been paired from the
main power switch.
FACTORY RESET
Lighting products:
Toggle the main power switch 6 times.
Motion sensor:
Press the pairing button 4 times within 5
seconds.
CHANGE BATTERY:
When unit is used regularly and as intended,
the batteries will last for approximately 2 years.
4
for at