KitchenAid KUDD01SSSS - 24" Single Drawer Dishwasher Manuel d'instructions d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid KUDD01SSSS - 24" Single Drawer Dishwasher. KitchenAid KUDD01SSSS - 24" Single Drawer Dishwasher 20 pages. Single drawer dishwasher

Imprimer la page

1. Location Requirements

Install the Drain Hose

A drain hose extension kit, part no. 8194400, will extend the drain

hose to a length of up to 141

beyond this length. The maximum drain height is 37

(95.25 cm).

Option 1: Sink drain waste tee connection

1. Route the drain hose as shown and press the hose into the

drain hose support.

2. Decide if the drain hose needs to be trimmed. If it does,

trim it.

NOTE: The drain hose connector must not support the weight

of excess hose length. Keep hose as

fully extended as possible.

3. Slip a wire clip over the drain hose.

Push the hose into the drain hose

connector firmly, 5 clicks.

4. Position the wire clip between the

two positioning ribs on the drain

hose connector.

5. Attach the drain hose connector to the waste tee using the

supplied hose clamp.

6. Attach the drain hose support bracket to the cabinet with a

#8 Phillips head screw at the height shown below.

IMPORTANT: A drain loop must be provided as shown in the

Installation Instructions. Keep hoses as fully extended as possible

to prevent sagging. Any excess length of hose should be kept on

the dishwasher side of the drain loop.

drain hose

support

valve

27-1/2" – 32-1/4"

(70 cm – 82 cm)

" (360.05 cm). Do not extend

wire clip

drain hose connector

6" (15.2 cm)

minimum

waste

waste tee

water supply

8" (20.3 cm) min. bend

radius from valve

Keep drain hose

straight, as shown.

Option 2: Garbage disposal connection