IKEA IDT930SAGX0 Instructions pour l'utilisateur - Page 12
Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} IKEA IDT930SAGX0. IKEA IDT930SAGX0 15 pages.
Imprimer la page
Filter Removal Instructions
1. Turn the upper filter assembly
¼ turn counterclockwise and
lift out.
2. Separate the upper filter
assembly by gently pulling apart.
3. Clean the filters as shown.
Cleaning Instructions
IMPORTANT: Do not use wire brush, scouring pad, etc., as they
may damage the filters.
Rinse filter under running water until most soils are removed. If
you have hard-to-remove soils or calcium deposits from hard
water, a soft brush may be required.
Cleaning the exterior
Clean the exterior of the dishwasher with a soft, damp cloth and
mild detergent. If your dishwasher has a stainless steel exterior, a
stainless steel cleaner is recommended - Stainless Steel Cleaner
and Polish Part Number 31464.
Cleaning the interior
Clean the interior of the dishwasher with a paste of powdered
dishwasher detergent and water, or use liquid dishwasher
detergent on a damp sponge to clean the cooled-down interior.
A white vinegar rinse may remove white spots and film. Vinegar is
an acid, and using it too often could damage your dishwasher.
Put 2 cups (500 mL) white vinegar in a glass or dishwasher-safe
2 cup capacity measuring cup on the bottom rack (do not pour).
Run the dishwasher through a complete washing cycle using
an air-dry or an energy-saving dry option. Do not use detergent.
Vinegar will mix with the wash water.
Dishwasher Maintenance Procedure
Removal of Hard Water/Filming: Recommended use of a
monthly maintenance product such as affresh
Cleaner Part Number W10282479.
Load your dishwasher (preferably with dishes affected by
■
filming/hard water).
Place tablet in main wash compartment of detergent
■
dispenser.
Select cycle/option best for heavily soiled dishes and start
■
dishwasher.
†affresh
is a registered trademark of Whirlpool, U.S.A. Used with permission.
®
12
Filter Reinstallation Instructions
1. Noting the previous
2. Insert the upper filter
3. Slowly rotate the filter
NOTE: The upper filter assembly
arrow does not have to align with
the arrow in the lower filter as long
as the filter is locked.
IMPORTANT: To avoid damage to dishwasher, do not operate
your dishwasher without the filters properly installed. Be sure the
lower filter is securely in place and the upper filter assembly is
locked into place. If the upper filter assembly turns freely, it is not
locked into place.
Dishwasher Care
CLEANING THE DISHWASHER
NOTE: Using a premeasured detergent tablet or pack for regular
daily use is recommended.
To Reduce Risk of Property Damage During Vacation
or Extended Time Without Use
■
■
■
If you have a drain air gap,
check and clean it if the
Dishwasher
dishwasher isn't draining
®†
well.
illustrations, place the
lower filter under the
locating tabs in the bottom
of the dishwasher so the
round opening for the
upper filter
assembly lines up with the
round opening in the bottom
of the tub.
assembly into the circular
opening in the lower filter
clockwise until it drops into
place.Continue to rotate
until the filter is locked into
place. If the filter is not fully
seated (still turns freely),
continue to turn the filter
clockwise until it drops and
locks into place.
When you will not be using the dishwasher during the
summer months, turn off the water and power supply to the
dishwasher.
Make sure the water supply lines are protected against
freezing conditions. Ice formations in the supply lines
can increase water pressure and cause damage to your
dishwasher or home. Damage from freezing is not covered by
the warranty.
When storing your dishwasher in the winter, avoid water
damage by having your dishwasher winterized by authorized
service personnel.
Drain air gap
To replace upper filter assembly