HIKVISION DS-2CE56D8T-IT3E Manuel de l'utilisateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} HIKVISION DS-2CE56D8T-IT3E. HIKVISION DS-2CE56D8T-IT3E 17 pages. Bullet & turret camera
Également pour HIKVISION DS-2CE56D8T-IT3E : Manuel de l'utilisateur (15 pages), Manuel de démarrage rapide (17 pages)
Imprimer la page
7. Tighten the screws with the screw driver.
8. Connect the corresponding cables, such as power
cord, and video cable.
9. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
1). Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust
the tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
2.2.2 Ceiling/Wall Mounting with Junction Box
Before you start:
You need to purchase a junction box in advance. The
installation steps of Type IV, Type V, and Type VI Camera
are similar and the following takes Type IV as an
example to describe the steps.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes on the ceiling/wall according to
the drill template.
Note:
Drill the cable hole, when adopting ceiling outlet to
route the cable.
3. Refer to step 3 of 2.1.1 Ceiling/Wall Mounting to
take out the camera's main body.
Figure 2-11 Assemble the Camera
Figure 2-12 3-axis Adjustment
Figure 2-13 The Drill Template