Gap Power Speedrooter 92R Manuel d'utilisation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Gap Power Speedrooter 92R. Gap Power Speedrooter 92R 10 pages. For 3” through 10” (75mm-250mm)

Imprimer la page

Speedrooter 92R

MAINTENANCE

DISCONNECT MACHINE FROM POWER SOURCE

BEFORE PERFORMING MAINTENANCE!

To keep your machine operating smoothly, it is essential that all bear-

ings be lubricated. Oiling moving parts is particularly important where

machine comes in contact with sand, grit and other abrasive material.

CABLE MAINTENENCE

To get maximum service from your cables,

be sure that they are clean and well oiled.

This not only provides running lubrication

but greatly extends the life of the cables as

well. Some users periodically pour oil di-

rectly into the drum. Then, as the drum

turns, the cables get complete lubrication.

Our SNAKE OIL is ideally suited for this

purpose, since it not only lubricates the

cables, it deodorizes them as well.

FEED MAINTENANCE

Keep feed free of excessive soil and grit. It is recommended that the

feed be flushed with fresh water followed by a light oiling of the mov-

ing parts. No disassembly is normally required. Failure to feed can

usually be traced to the following possibilities:

DIRT ACCUMULATION

Over time, dirt can harden enough to stop roller rotation. Flushing

with water followed by liberal oiling can usually restore function. If

disassembly is required, proceed as follows:

Remove the feed tension knob, springs and spring plunger. Note

the positioning of these parts to ease re-assembly. The top roller

can now be removed.

Remove the end caps and thrust washers from the bottom hous-

ing cylinders. The bottom rollers can now be removed.

Re-assembly is done in reverse order.

DAMAGED ROLLER

Excessive use may wear a roller to the point of failure. It is recom-

mended that all three rollers be replaced at the same time (Cat # PO-

703). The replacement roller is an assembly consisting of one (1)

Feed Roller, two (2) Feed Roller Bearings, and two (2) Bearing Spac-

ers.

Note: The Bearing Spacers must be installed between the Carrier

and each Feed Roller Bearing (as illustrated below) in order to

ensure proper operation and to obtain maximum Feed Roller life.

To Replace the Feed Roller Assembly:

Remove the Feed Roller Assembly by unscrewing and removing

the Feed Roller Axle.

For convenience, the components are assembled and wired

together at the factory. Before attempting to install the assembly,

hold the assembly together and remove the wire.

While still holding the Feed Roller Assembly together, insert it

into the slot opening of the Carrier.

In order to help align the Spacers and Bearings, insert a pencil

point or similar object through the un-threaded end of the Axle

hole in the Carrier. After removing the pencil point, continue to

maintain the alignment of the components.

The Feed Roller Axle should then be inserted through the same

un-threaded Axle hole and should continue to be guided through

the Spacers and Bearings to the threaded Axle hole on the other

side of the Carrier.

Securely tighten the Axle to the Carrier with a 3/16" allen wrench.

TANGLED CABLE

If a cable loops over itself in the drum, it will not feed properly. Re-

move and reload the cable to restore function. If the cable kinks, it is

evidence of abuse and results from the use of too much pressure or

use of the wrong size cable for the line. Do not force the cable — let

the cutter do the work.