BERNHARDT design a.k.a. C-base Manuel d'instructions - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} BERNHARDT design a.k.a. C-base. BERNHARDT design a.k.a. C-base 20 pages.
Imprimer la page
Step 15
It is very important that the Workwall sections are very
straight from side to side. Any contour along the length of
the Workwall rails will make the remaining installation more
difficult.
Step 16
With the Workwall Structure level, flat and mounted
secure, it is time to install the Workwall Panels. The
number of panels will vary depending on the setup. The
bottom edge of the Workwall Panel is marked with a letter
and a number. Always work from left to right, top to
bottom. The letter on the bottom of the panel indicates its
position left to right. The number on the bottom of the
panel indicates its position top to bottom. Letter A will be
the leftmost panel. Number A1 will be the top left panel.
To install the Workwall Panels, simply align between the
proper aluminum rails on the Workwall Structure, and push
in place. There will be a positive engagement between the
Workwall Panels and the Workwall Structure. Continue
the process working left to right, bottom to top until all
panels are installed.
Step 17
Once all of the Workwall Panels are installed we
recommend that any overhead unit is installed next. This
will allow for any lighting wires to be run prior to the
installation of the end caps.
September 2012