Jamara 06 1172 Manuel d'instructions - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Jamara 06 1172. Jamara 06 1172 8 pages.

Imprimer la page

Binding

As with all 2,4 GHz systems the transmitter and the receiver must

be bound together and this process is vital. Before the system is

bound together it will not function and therefore cannot be used

and so the following steps must be followed before you attempt to

operate the system:

1. Fit the binding plug to socket 3 on the receiver and connect

the power supply. The receiver LED will begin to blink:

2. Press and hold down the binding button on the transmitter

and switch the power on. This will put the transmitter

into binding mode.

Settings

Before you operate your model carefully check that the servo op-

erate in the correct direction. If they do not rotate in the correct

direction use the servo reverse switches located on the front of the

transmitter to change the direction.

Switching On

1. Connect all of the components together.

2. Switch ion the transmitter.

3. Connect the power supply to the receiver and switch on if re-

quired.

4. Check that all of the LEDs are correctly illuminated.

The system is now switched on and ready to operate.

Operating The Model

Steering

This function is used to steer the

model in the correct direction.

Moving the steering stick to the

left or right will make the wheels,

or hull if operating a boat, move

in that direction. Moving the stick

to the left should make the model

steer to the left.

3. Once the binding process has ﬁ nished the LED will shine.

4. Switch the transmitter and receiver off.

5. Remove the binding plug.

Important Information

The system will not function whilst the binding button is pressed.

Also, the system should not be left in binding mode for long peri-

ods of time.

The servo neutral positions should then be set by moving the servo

arms until they are at exactly 90

should only be used to make ﬁ ne adjustments when operating the

model. If you are using this system with an Internal Combustion

engine make sure that the linkage cannot bind in either the full

throttle or tick-over positions.

Switching Off

1. Switch off and unplug the receiver power supply.

2. Switch off the transmitter.

Throttle

This function is used to make the

model move forward or in revers

and it also is used to control the

model's speed. Pushing the stick

forwards makes the model acceler-

ate forwards and pulling it to the rear will make the model brake

ﬁ rst and then to accelerate in reverse.

- 5 -

with the trim central. The trim