Makita 2012NB Manuel d'instruction - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 2012NB. Makita 2012NB 13 pages. Thicknesser
Également pour Makita 2012NB : Manuel d'instruction (14 pages), Manuel d'instruction (13 pages), Manuel d'instruction (20 pages), Manuel d'instruction (17 pages)
Imprimer la page
Clean out all chips, dust, pitch or foreign matter
•
adhering to the drum or blades before installing the
blades.
Use blades of the same dimensions and weight , or
•
drum oscillation/vibration will result, causing poor
cutting action and eventually, tool breakdown.
Replace both blades at the same time.
•
The disposable-type blade has a cutting edge on
•
both sides. When one cutting edge becomes dull,
you can use the other cutting edge. Always remove
resin and dirt sticking to the reverse side of the
blade before using the other cutting edge. This
blade must not be re-sharpened. When both cutting
edges become dull, the blade should be carefully
thrown away.
1.
Removing blades
Loosen the thumb screw which secures the chip cover
and remove the chip cover. Remove the screws which
secure the right side cover. Then remove the right side
cover. Turn the pulley until the drum can be locked in the
position whereby the blade installation bolts face upward.
1
2
4
003715
For throw away blades only
Place the two magnetic holders on the set plate and push
them in the direction of the arrow until the claw contact
the blade. Remove the six blade installation bolts using
the socket wrench. Grip the magnetic holders and raise
them straight up to remove the set plate and the blade
from the drum. Press the lock plate and turn the pulley
180° to lock the drum. Remove the other blade as
described above.
1
2
4
5
003716
1. Lock plate
3
2. Drum
3. Thumb screw
4. Pulley
1. Blade installation
3
bolts
2. Set plate
3. Magnetic holder
4. Drum
5. Blade
6. Claw
6
1
2
003717
For standard blades only
Remove the six installation bolts using the socket wrench.
Raise the set plate and blade straight up to remove them
from the drum. Press the lock plate and rotate the drum
by turning the pulley 180° to lock the drum. Remove the
other blade as described above. Remove the set plate
from the blade.
1
2
004468
1
004469
1.
Installing blades
CAUTION:
Use only Makita socket wrench provided to tighten
•
the blade installation bolts. The use of any other
socket wrench may cause overtightening or
insufficient tightening of the bolts, resulting in
severe injury.
For throw away blades only
Provide a flat wood block approximately 300 mm long
and 100 mm wide. Place the blade and the set plate on
the wood block so that the blade locating lug of the set
plate rests in the groove of the blade. Adjust the set plate
so that both ends of the blade protrude approximately 1
mm beyond the end of the set plate. Place the two
magnetic holders on the set plate and push them until the
claw contacts the blade.
6
1. Socket wrench
2. Magnetic
holders
1. Socket wrench
2. Lock plate
3. Blade installation
bolt
3
1. Set plate